Economical and Reliable Liquid Level Monitor
One of our most reliable and economical liquid level monitors is recommended for small tank applications with depths of 6" up to 30".
- Highly visible "top reading" or "Side Reading" tank level monitor. (Not side mount)
- Tough, acrylic calibration dome.
- Level monitor available in 1 1/2" and 2" openings. Also has several custom bushings listed below.
- The lowest profile liquid level monitor amongst the Krueger Gauge product line.
The L Gauge Overview
What it is
Top mounted liquid level gauge that can measure the level of smaller tanks. Comes in any size from 6 inches to 30 inches. The L Gauge is not a side mount gauge. Must be top mounted.
Additional Options - Not Included
Several alternative bushings and options are available.
- Fits through 1.75 inch diameter opening/ hole.
- No tank fitting required.
- Duro Nitrile gasket seals it from the top and bottom.
- Must have access to the tank opening from the inside of the tank.
- 1 - 5/16" flange for welding or soldering to tank.
- Standard material is CRS (cold roll steel)
- Also available in a 5 bolt hole pattern. (aluminum)
Instructions for Operation
- Unthread the red locking nut. Separate the aluminum bushing from the rest of the gauge. (do not lose the rubber gasket)
- Thread the aluminum bushing into the female fitting on the top of your tank.
- Drop gauge through the center of the aluminum bushing float first. Be sure your gasket is still in between the top of the bushing and the calibration.
- Be sure your swing arm is pointing to an open spot in the tank, avoiding walls, corners, baffles or other obstructions.
- Tighten your red locking nut and calibration down to the aluminum bushing. Hand tighten the red nut until snug. If a tool is required, use care not to break the red nut
|
Material Description: Liquid Level Gauge. Galvanized Steel Rods. Aluminum Bushing. HDPE Plastic Float. HDPE Plastic Lock Nut |
Material Description: Liquid Level Gauge. Stainless Steel Rods. Aluminum Bushing. HDPE Plastic Float. HDPE Plastic Lock Nut |
|
Opening Size Description: Standard is NPT. National Pipe Thread |
|
Tank Depth Desciption: Level of Liquid being. measured in tank. from empty to full. (provide measurment in inches.) |
Opening Size Flange Style: 1.65" flange for tanks with no fitting (requires 1.65" hole) |
|
ALN-Replace the Red HDPE Lock Nut with an Aluminum Lock Nut |